Cold Bending Machinery And Equipment Instructions

Cold Bending Machinery And Equipment Instructions

Cold bending machinery and equipment is a very popular equipment in many industries, and cold bending machinery and equipment has become a widely used machinery in some factories, so what problems should be paid attention to when using cold bending machinery and equipment?

Before using the cold bending machine, the power supply and switch must correspond to the corresponding rated voltage of the equipment. If the equipment is using 380v three-phase AC, the allowable current of the switching power supply should not be less than 10A. Effective professional installation is necessary at the same time, because only through the correct installation to ensure the normal operation of equipment in the process of using, so as to ensure the use effect of the final, what need reminds is here if you want to guarantee the effective installation, be about to choose high quality professional equipment sales companies, because the enterprise can not only provide the most professional and effective installation, At the same time can also provide you with good technical support and after-sales service, thus greatly improving the use of experience.

Before using processing need to put the cold bending steel equipment idling 1 to 2 minutes, in order to better to eliminate some unnecessary trouble, and then when sure not any defect on to the next step of operation, then in time by one person to control a unified command operation, avoid people caused by the confusion, Then it is to listen carefully to the command of the correct operation, when the use is finished, according to the correct sequence to shut down the machine.

In the use of cold bending mechanical equipment, it is necessary to choose flat table, put the machine, you can pull the chassis feet to make the machine panel easy to observe. At the same time, it is also necessary to insert the plug on the handheld sensor head into the socket on the panel, and tighten it at the same time, paying attention to the location of the gap. Then insert the plug of the power cord into the socket, and then turn on the power switch of the chassis. When the green indicator light is on, the machine can work, then press and hold the corresponding setting button to set the appropriate value. At this time, put the sensor on the container cover, press the start button on the handle, then the heating red indicator light is on, indicating heating, do not remove the sensor head, when the heating red indicator light is off, then remove the sensor light. Wait until the machine after the beep, you can carry out the next container sealing operation. Check the sealing quality, according to different materials, diameter of the container production efficiency, appropriate dressing set button keys, so that the sealing quality is good.

Above is all about the use of cold bending mechanical equipment, in addition, there are still a lot of attention in this not described one by one, cold bending equipment as the widely used equipment, has a broad prospect, with the constant progress of science and technology, believes that the use of cold bending device will appear in every aspect of our lives, is our life more convenient.