Views: 0 Author: Site Editor Publish Time: 2022-01-24 Origin: Site
Operation flow of cold bending machine
Cold bending forming machine is a plastic processing process machine that continuously transversely bends the coil, strip and other metal plates to make specific section profiles through multi-pass forming rollers in sequence configuration.
Its unique structure, with small volume, low energy consumption, high efficiency, no noise installation, easy to use, simple operation, strong load, long life, fast winding speed, reliable product quality and other advantages. Using this machine, not only can produce high quality steel products, but also can shorten the cycle of product development, improve production efficiency, so as to improve the market competitiveness of enterprises. Therefore, the correct operation of the cold bending machine is particularly important. The following is the correct operation of the cold bending machine process:
1. Operation must wear complete labor protection supplies, otherwise not allowed to participate in the operation, not laughing and slapdash at work so as not to disperse energy, resulting in accidents.
2. Before starting the machine, check the online guide part carefully, and carefully inspect the subsidiary equipment and safety protection device of the unit. If any problem is found, it shall not start the machine, and report and deal with it immediately. When the upper slide plate and each positioning axis are not in the origin state, run the back to the origin program. Also check the consistency and firmness of the upper and lower molds, check whether the positioning device is in line with the requirements of processing. Ensure that all devices are in safe and normal state before starting.
3. Strictly abide by the regular operation rules of machine tools.
4. Before starting, carefully check whether the motor, switch, circuit and grounding are normal and firm, and check the operating parts of the equipment. The button is stuck in the correct position.
5. After the equipment is started, it will run for 1-2 minutes, and the skateboard will move 2-3 times in full journey. If there is abnormal sound or fault, it should stop immediately and remove the fault.
6. When working, it should be under the unified command of one person, so that the operator and the feeding and pressing personnel closely cooperate, to ensure that the coordination personnel are in the normal position of the cold bending signal.
7. The sheet must be compacted during cold bending to prevent the sheet from becoming warped and wounding people.
8. The power supply must be cut off when the plate is pressed, and the operation must be stopped
The above is the factory summary about the correct operation of the cold bending machine basic process, hope to help. If you have any questions, please come and consult.