The installation process of elevator guide rail productions.

Elevators and escalators can be seen in many places. Such as shopping malls, office buildings, residential communities, etc. But many people don't know elevator guide rail productions. In this article, I will introduce some knowledge about elevator guide rail productions, I hope it will be helpful to you.

• The installation process of elevator guide rail productions.

• Problems in the installation of elevator guide rail productions.

• Elevator guide rail productions owned by Zhang Yun Machinery.

Elevator guide rail production and installation process.

(1) According to the provisions of GB10060-20114.2.7, the lower end of the car guide rail and the counterweight guide rail with safety gear should be supported on a solid elevator guide rail production seat on the ground. The pit guide rail seat must be flat, the levelness should not exceed 1/1000, the height is generally 60mm, and the surrounding should be filled with concrete;

(2) Check that the straightness of the elevator guide rail production is not greater than 1/6000, and the elevator guide rail production that does not meet the requirements must be corrected or replaced. Check whether the tongue and groove on the production end of the elevator guide rail is damaged. It can be installed after cleaning;

(3) Use a hoist to hoist the elevator guide rail products one by one, and install them from bottom to top. The top guide rail should be cut off according to the actual length before hoisting;

(4) Adjust the elevator guide rail production from bottom to top with the school rail ruler, and correct the deviation immediately if it is found.

Problems in the installation of elevator guide rail productions.

The elevator guide rail products were not put into the warehouse according to the standard after unpacking, which caused the elevator guide rail products to rust and twist. The on-site installer was unable to correct the production of elevator guide rails. The installation team directly installed the twisted rails on the bottom or top floor. The verticality of the measured rail exceeds the standard and cannot be corrected.

Elevator guide rail productions owned by Zhang Yun Machinery.

Zhangyun Machinery Company is a company specializing in manufacturing advanced multi-material, multi-thickness, multi-shape cold bending equipment, high-frequency welded pipe equipment, special equipment for auxiliary processing of elevator guide rail production, and non-standard automated production lines. Our high-performance roll forming system can process a large number of different types of high-quality profiles. Products related to the  elevator guide rail productions include: semi-automatic wire twisting machine, automatic metal processing production line, derusting machine, coating machine, manual straightening machine, planer, oiling machine, etc.

If you are satisfied with the products produced by our company (Zhang Yun Machinery)  elevator guide rail production, you can go to our company to view the products produced by elevator guide rails making, or you can order products. Our company specializes in manufacturing cold-formed forming equipment, high-frequency welded pipe equipment, and elevator guide rail auxiliary processing equipment. Looking forward to your visit, I wish you success in your work.

If you have related needs, welcome to our company's official website: https://www.zyjxzz.com. Thank you very much for your support.