Use cable tray molding machine to test machine

Use cable tray molding machine to test machine

Cable tray forming machine is a main production of cable tray equipment. The tray produced by the equipment is formed once without secondary processing. Usually test machine is for the normal operation of equipment and for the sake of. In the case of no-load test machine for a certain period of time, in this certain time if there is no abnormal situation can continue to work, if there is no test link, direct work, then abnormal situation will seriously damage the equipment and may bring certain risks to the operator. The trial time is usually a few minutes, not very long. The project schedule can not bring much loss, so the test machine before the cable bridge forming machine is important.

1. Test and check the balance cylinder action of cable bridge forming machine and oil circuit and joint of oil lubrication system.

2. The friction between the slide block of the cable bridge forming machine and the guide rail is more frequent. Necessary adjustment and correction should be made to check the lubrication and pipeline of the joint part for good operation.

3. Lubricate the gear part of the cable bridge forming machine regularly: the possibility of damage to the gear transmission box and internal parts is greater because of frequent operation, and the possibility of loosening is greater.

Cable tray forming machine equipment is numerous, only in operation can find the problem. However, if there is abnormal load, it will cause great damage to the equipment. So empty load testing machine is better.